Q&A

Monitoring the flue gas temperature leaving the process convection section is a simple method of tracking the heat transfer in the convection section. The excess air needs to be taken into consideration as a higher O2 concentration will shift heat transfer into the convection section and causes the total quantity of flue gas to increase.

For conventional fouling, which is the result of asphaltene destabilization due to temperature, chemical treatment programs have not been effective for Coker heaters. For premature asphaltene precipitation due to resid compatibility concerns, chemical treatment programs have been effective in reducing or eliminating fouling.

The quantity of coke is heavily dependent on reactor technology, feed quality, and operating conditions. In earlier termination devices the riser outlet was open to the reactor. The vapors would spend a lot of time in the reactor resulting in coking.

The performance of swirl tubes is comparable with cyclones in terms of separation efficiency. Swirl tubes have distinct advantages over cyclones in being more compact, much easier to construct and have high mechanical integrity.

ABIGAIL SLATER (HollyFrontier)
Salting typically occurs in the reactor effluent exchangers (shell and tube and fin fans), recycle and net gas compressors, and product stabilizer overhead system (top trays, overhead condenser, etc.). Common monitoring practices on exchangers and fin fans can be

DAVINDER MITTAL (HPCL Mittal Energy)
Chlorides have been a long standing issue in catalytic reformer operation. Until a few years ago, the focus on preventing operational problems from the chloride compounds in the catalytic reformer product stream was to remove HCl.  More recently, a growing

BILL KOSTKA (AXENS NORTH AMERICA)
Metal-catalyzed coke (MCC) formation typically occurs on 3d valence transition metals such as iron and nickel.  Under CCR-like conditions of low hydrogen partial pressure (less than about 620 kpa), high temperature (more than about 480 °C) and low or stagnant flow

BILL KOSTKA (AXENS NORTH AMERICA)
Liquid-phase Cl treaters are typically used in three locations for reforming units.

Treating the unstabilzed reformate stream provides several advantages.  The stream is heated upstream of the stabilizer column which ensures that any ammonium chloride is

ABIGAIL SLATER (HollyFrontier)
The most impactful parameter affecting alky acid consumption is feed quality. Reducing feed contamination will greatly reduce acid consumption. There are also operational changes that can be made to reduce acid consumption, but the biggest impact will be feed

KAISER (Delek Refining Ltd.) The question is very well phrased in that the introduction of ethanol into the blend pool does tend to reduce the need to run the isomerization unit in that ethanol is a very high RVP blend component, and it has enough octane to be able to possibly offset the need for the octane boost that you’re getting out of your isomerization unit. So when a refiner wants to introduce the ethanol into their blend pool, there are three likely scenarios that they’ll go through in their unit operations. The first is obviously shut the isomerization unit down.