Q&A

Question 49: In the past year, a sulfuric alkylation unit released a significant amount of sulfur dioxide to atmosphere when light hydrocarbon flowed from the reaction zone through the acid blowdown system and into the spent acid tank. What measures do you recommend for preventing this?

We would recommend ensuring that the acid knockout drum be sized large enough to allow the hydrocarbons to disengage in the drum.

Question 51: Reforming unit stabilizer column top trays and overhead condensers can experience fouling with ammonium chloride salts, which are commonly removed by online water washing of the column overhead. What practices do you employ to reduce the risk of rapid corrosion and the potential failure associated with this fouling and subsequent water washing procedure?

Ammonium chloride salts are a common problem in both naphtha reforming and naphtha hydrotreating units.

Question 60: How do you detect leaks in an isomerization unit's steam charge heater? Have you been able to detect a leak before a significant portion of the catalyst bed was deactivated?

The common problem in these units is deactivation of the catalyst by the ingress of water over the catalyst, because water actually deactivates the catalyst. This is a slide of a typical flow scheme for these units, and kind of shows you the conundrum of designing and operating these units.

Question 61: Have you found that you needed to install a methanator upstream of a chlorided catalyst isomerization unit to remove carbon monoxide (CO) from the feed? What is the source of the CO and how much of a difference has the addition of the methanator made to catalyst life? What is the expected payout for the cost of the methanator?

The problem now comes from the oxygen ingress coming in with makeup hydrogen, with the culprit typically being CO and CO2.

Question 7: What are your typical precious metal recoveries from reforming catalysts? What factors impact this?

BILL KOSTKA (AXENS NORTH AMERICA)
Reported platinum recoveries from reforming catalyst following commercial utilization have typically ranged between 90 and 100 wt% and have rarely been less than 80 wt%. The magnitude of this range is both frustrating and at least somewhat explainable.

How one

Question 6: Do LTOs contain higher concentrations of nitrogen? If so, how has this higher concentration effected gasoline processing units?

The LTOs generally do not contain a higher concentration of nitrogen. LTOs are typically characterized as light, sweet, low-sulfur, low-nitrogen crudes. For example, the Eagle Ford and the Bakken nitrogen typically contains less than 2 ppm. Nonetheless, the gasoline processing units are impacted when refineries process higher percentage of the LTOs because of the crudes.

Question 44: How is coke on catalyst in fixed-bed and moving-bed reforming units tracked? How is this data used to adjust the reactor inlet temperatures in order to maintain constant product octane?

In our cyclic units, just based on the air consumption, we can measure the coke each time a reactor comes out for a regen. We are not grabbing samples. Our experience with the cyclics is that if you get up around 8% coke on catalyst, the unit will be pushed a little too hard. You will then need to think about backing it down on feed rate octane, finding a better-quality feed, or possibly increasing the hydrogen/oil ratio.

Question 49: Does the panel have any experience using flexible thermocouples in the regeneration section of a moving-bed reforming unit? What considerations should be given to revamping units that do not have these installed?

Flexible thermocouples, as I understand, are now a part of the standard design for regenerators of moving-bed units. At a refinery in which I worked; we replaced the original slider thermocouples with multipoint thermocouples.

Find the answer to your technical question in AFPM's extensive Q&A database.

Q&A